Ingenico Move3500 Bluetooth/WiFi
Connectivity: Bluetooth (via ethernet or phone line) and WiFi (remote log in to a secure network)
...
ethernet socket/phone line port
First steps
To charge the terminal, plug the charger directly into the top left hand side of the device, or by plugging the angled charger into the base unit, through removal of the back panel
To power up the terminal, press the green [enter] key
WiFi Set Up:
Press the down key
Select ‘Control panel, ‘Terminal settings’, ‘Comm means’, and then ‘WiFi’
Choose ‘Enable’
Select ‘Scan networks’ and press the enter key, the terminal will scan for available networks
Select the desired network
Enter the WiFi password and press enter
A confirmation screen will display reading ‘New Profile OK’
The WiFi symbol at the top will have turned green.
4. Bluetooth Set Up:
Firstly, the base unit has space for either an ethernet cable or a phone line (we would always
...
If connection has been established, the LAN symbol (3 squares) should appear green
Select ‘Control panel, ‘Terminal settings’, ‘Comm means’, and then ‘Bluetooth’
In Bluetooth configuration, select ‘Base’ then ‘Association’ and ‘New Base’
The screen will then read ‘Association successful’ and the device will reboot
Ingenico Move 3500 3G
Connectivity: SIM card (automatic or manual mode)
...
Location: place the charging unit is in a convenient location, close to a power source
First steps
To charge the terminal, plug the charger directly into the top left hand side of the device, or by plugging the charger into the base unit
To power up the terminal, press the green [enter] key
The terminal should already be connected to 3G via the SIM (automatic mode), however if you wish to switch to manual:
Press the down key
Select control panel
Select terminal settings
Select communication means
Select mobile network
Scroll down to select network
Switch from auto to manual and then select 'O2'
Reboot the device by holding down the yellow and the full stop/comma button together
How to Test your Connection - Move3500 Series
Press menu twice (bulls eye button)
Select supervisor
Enter the code
Press menu again
Select 'call TMS'
If a connection is made via your chosen method, it will run through a configuration
The receipt should read 'TMS call - Connected 'OK' and Config Data 'OK'
...